Downhill bike rushing high-speed When cornering at high speed (some people call it a bend), you can try to bend and pass when there is no oncoming vehicle on the opposite side, the road is in good condition, and there are no leaves, sand and other foreign objects on the road, and you need to pay attention to the following points when cornering at high speed:
(1) Before entering the curve, step on the outer pedal, and the inner side is naturally raised (if you turn to the left, the right pedal is stepped down, and the left pedal is raised, and vice versa).
(2) The center of gravity is placed on the outer pedal, the buttocks are slightly lifted on the feet, and it is not necessary to leave the bicycle - the seat, which aims to lower your center of gravity and make the car more stable, and try to make the center of gravity drop from the seat to the pedal. superior.
(3) Bend down the upper body, lower the center of gravity of the body, and firmly hold the inner handlebar. It is a bit like pushing the handlebar to the outside and exerting some force. The outer palm gently pulls the handlebar. The result of this push and pull is the same, in order to facilitate The car cuts and turns smoothly.
(4) When starting to corner, put the inner leg against the upper tube of the frame, and when the inner leg is against the upper tube of the frame, the hips will naturally move to the outside, and the car will plunge into the corner at a high speed, and it is still completely controllable range.
(5) Lower the body to the side of the turning direction to counteract the force exerted by your outside foot on the pedal. When cornering, the bike is slanted, the upper body is slightly shifted to the other side of the curve, and the balance of the bike is controlled by the weight exerted on the pedals by the outside foot.
(6) Naturally restore the body tilt angle after cornering, and prepare for the next corner depending on the road condition.
